Switching on the software synchronization. SofTec Microsystems is always on. With your Mobile Internet Key, you can enjoy a full high speed Internet experience on the go. The logged data is saved on industrial-grade SD cards see section Memory Card on page Only in Logger Mode: The logging is not stopped. Instructions on editing files are found at these points.
|Date Added:||20 July 2008|
|File Size:||44.20 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Remove the FlexRay cable if it is connected. Though, and it s compatible cancasexl driver many versions, from release.
For information on installing transceivers please refer to section Replacing Piggybacks on page Device is waiting for trigger. Common time stamp clock for each channel.
To insert a SD card push it until it latches bbit place securely. This symbol calls your attention to warnings.
The tool gives you information on the connected and installed Vector devices. Cancasexl driver windows 7.
Example Program Drafts
The trigger input is low active, i. The License section contains information on all currently valid licenses.
Measurement data monitoring with testo Saveris SBE Startup instruction 2 1 System requirements 1 System requirements Operating system The software can be run on the following bit and bit operating. An OK should appear in the upper part of the window. All trademarks, trade names or company names are or can be trademarks or registered trademarks of their particular proprietors. No part of this manual may be reproduced in any form or by any means without the written permission of the publisher, regardless of which method or which instruments, electronic or mechanical, are used.
System Requirement and Connection To remove the SD card push it into the holder slot a little bit until it unlatches then let it go and it will spring out of its latched position.
We are grateful for references to mistakes or for suggestions for improvement to be able to offer you even more efficient products in the future. For further information please refer to the relevant application manual.
Vector News – Vector Driver Setup: New Version
It is responsible for the correct timing of the integrated clock. The time stamp deviations from different Vector network interfaces are calculated and synchronized to the common PC clock. This User Guide provides step by step instructions that will take you through Bkt information. On some PCs with Windows7 64bit and Keyman 64bit driver installation a license file update does not work.
All trademarks, trade names or company names bih or can be trademarks or registered trademarks of their particular proprietors. If two different voltage supplies are being used for logger and test equipment, the ground GND pins of the two voltage supplies must be connected.
The hardware synchronization must be supported by the application. Please use the 32bit Vector.
Manual. CANcaseXL CANcaseXL log. Version English – PDF
Too high data rate, messages are lost. For this purpose no further hardware setup is required. Device is booting in Logger Mode. Please note that the software synchronization must be disabled see Vector Hardware Config General information Settings Software time synchronization if the hardware synchronization is used. Close the housing by cancaexl light pressure, and then secure it with the appropriate screw fasteners. The logging is not stopped but the LED state cancasex, not change till the device is rebooted.
It is also possible to receive and analyze Remote Frames without any limitations. You will see statistical data in the lower part of the window if the system has been configured properly.